Setting Up My PM935 Mill
(11-27-2015, 07:49 PM)f350ca Wrote: Set up the way you have it in the last photo Ed, with the head sitting on the table. You should be able to hook up the hoist to stabilize it and retract the arm on the column till the studs are clear.

Yup, that's my plan. Smile

Ed
Reply
Thanks given by:
Got the pallet cut away so I could get the cherry picker in far enough to lift the head off. Ruined three reciprocating saw blades in the process. I think it's stable as is so I can start removing pieces.  Sweat

Ed

         


         
Reply
Thanks given by:
Well this is not going to work. I guess I need to cut those wings off so I can get the cherry picker in further. Good thing I've got three more blades.

Oh, and that lifting strap is not the only one I'll be using.  Yikes

Ed

       
Reply
Thanks given by:
Popcorn
Reply
Thanks given by:
Progress.

There is some!

Smiley-dancenana
Reply
Thanks given by:
Popcorn ANY THING HAPPNEN?
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
(11-28-2015, 06:52 PM)PixMan Wrote: Progress.

There is some!

Smiley-dancenana

Slow as it is, it's progress none the less. Smile

Ed
Reply
Thanks given by:
(11-28-2015, 07:19 PM)ieezitin Wrote: Popcorn ANY THING HAPPNEN?

No, go back to sleep. Big Grin

Ed
Reply
Thanks given by:
Slow progress is still progress Ed.  This is something that you don't want to rush,  as the consequences are serious.   Whilst this is probably not going to be of much use here, here is a picture of the stand that I made to remove the head from the knuckle on my Kondia:

http://www.metalworkingfun.com/thread-57...l#pid42783

Perhaps if you have a large enough piece of round stock held in a collet, you could do the same.  It really does make getting the head off and on so much easier, as the mill holds the weigh and you use the various axis to line everything up and keep it aligned and level.
Hunting American dentists since 2015.
Reply
Thanks given by: EdK
(11-27-2015, 07:49 PM)f350ca Wrote: Set up the way you have it in the last photo Ed, with the head sitting on the table. You should be able to hook up the hoist to stabilize it and retract the arm on the column till the studs are clear.

Worked like a champ Greg. I have head freedom.  Smile

Next, lunch then head extraction.

Ed

         
Reply
Thanks given by:




Users browsing this thread: 26 Guest(s)