Small outdoors home-made CNC plasma table
#1
Photo 
I built this 2' x 2' capacity CNC plasma table using mostly off-the-shelf parts from industrial supply houses.  It sits under my deck outside my basement door, with the plasma cutter, air compressor, and computer just inside.  The cables can be connected in 5 minutes.  I protect it with a fire pit cover when not in use.

By being outside, besides saving precious indoor space, the problems of debris, plasma dust, go away.  Below are a few photos of it and some shapes I have cut with it.  The motorcycle shapes are approximately 19" long.

                                                   
Reply
Thanks given by:
#2
Smiley-signs046 Nice work!
Willie
Reply
Thanks given by:
#3
Love the Christmas decorations!
Full of ideas, but slow to produce parts
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)