626 milling machine converted to CNC
#11
all cuming to plan well dun rob
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#12
Cheers Lads Big Grin


Spun the nut 90 deg and machined of the excess from the nut mount .
[Image: normal_P1040970.jpg]

Plenty of room for the pulley and the nut to pass Smiley-dancenanaSmiley-dancenanaSmiley-dancenanaSmiley-dancenana
[Image: normal_P1040969.jpg]
[Image: normal_P1040968.jpg]
I will have to make a new nut mounting block as it looks naff as is Slaphead


Rob
Reply
Thanks given by:
#13
Hi Lads Big Grin


Made a start on the Z axis bearing mount ,,,,,, chopped a wee bit of one of my large lumps of scrapbinium .
[Image: normal_P1040971.jpg]

Slapped it in the CUB lathe ,, for turning and boring ,,,,,,,,,,,,ruffing shot.
[Image: normal_P1040978.jpg]

And a few hours later ,,,,,,,,,, all the turning and boring done .
[Image: normal_P1040984.jpg]
[Image: normal_P1040985.jpg]

Enough for today ,,,,,,,,,,,,,i will stick it on the mill tomorrow .


Rob
Reply
Thanks given by:
#14
Rob,

Nicely done Smiley-signs107

Shiny as ever Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#15
Very nice RobWorthyWorthy
I see that special camera lens is working fine now (the one that hides all the machining marks)Big GrinBig GrinBig GrinBig Grin
John
Reply
Thanks given by:
#16
well dun rob you got the polish out avent you
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#17
RotflRotflRotfl cheers lads Big Grin


I did not get as much done to this today as i would have liked ,, i had a few other small projects to get out of the way :dremel: ,,,,,, milled up the edges of the block as i had just left them ruff sawn as the job was gripped in the four jaw for turning .
[Image: normal_P1040991.jpg]
[Image: normal_P1040995.jpg]
now it fits into the knee.
[Image: normal_P1050007.jpg]
turned up a gauge from a bit scrap bar , to gauge the fit between the lugs .
[Image: normal_P1050012.jpg]


Rob
Reply
Thanks given by:
#18
Rob,
Looking good Smiley-signs107 Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#19
Not a bad finish on that bit of "scrap bar"
I cant remember a cylindrical grinder in your shopWorthyWorthyWorthy
I don't think you will have any problems with flex on that block
John
Reply
Thanks given by:
#20
Rob,

Absolutely gorgeous parts you're making. Keep the pictures coming. 6820

Ed
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)