P&W 1830 Radial in 1/6 scale.
#1
I have many hours into this engine at this point. If you wish I can start from the beginning or here?

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#2
Bill,

From the beginning please Bill WorthyWorthyWorthy

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
OK square one it is. I started with the rear gear housing. 5.250 dia 4.750 long 7075. Remember again this is being done on a 9 inch import. One key note, there is no casting for this part, it and most of the others are barstock. Only the heads and pistons will be from castings.

"Billy G"


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#4
(06-30-2012, 07:53 AM)Bill Gruby Wrote: Remember again this is being done on a 9 inch import.
"Billy G"
Bill, Isn't it a "modified" and "Tuned" 9 inch import Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#5
Pulled my chair up and got my soda, ready for the long haul.

Ron
ozzie46, proud to be a member of Metalworking Forum since Mar 2012.
Reply
Thanks given by:
#6
(06-30-2012, 08:09 AM)DaveH Wrote:
(06-30-2012, 07:53 AM)Bill Gruby Wrote: Remember again this is being done on a 9 inch import.
"Billy G"
Bill, Isn't it a "modified" and "Tuned" 9 inch import Thumbsup
Smiley-eatdrink004
DaveH


Just a little. Rotfl

"Billy G" Smiley-dancenana
Reply
Thanks given by:
#7
(06-30-2012, 08:20 AM)ozzie46 Wrote: Pulled my chair up and got my soda, ready for the long haul.

Ron


You may have to change chairs before this is over. Rotfl

"Billy G" Thumbsup
Reply
Thanks given by:
#8
On the face plate boring the dtarter hole. Starter meaning electric starter. It will also sport a variable pitch prop when running. Don't let this pic fool you, there are two more bolts holding that mass from the other side.

"Billy G" Thumbsup


Attached Files Thumbnail(s)
   
Reply
Thanks given by:
#9
OOOOKKKK!! I'm on board Bill,Thumbsup

the train can now leave the station.Big Grin

O and I brought popcornPopcorn

This will be good Drool

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#10
Back into the three jaw to bore the main hole.

"Billy G" Smiley-dancenana


Attached Files Thumbnail(s)
   
Reply
Thanks given by:




Users browsing this thread: 5 Guest(s)