Todays Project - What did you do today?
Knocked up a cable tie holder from a few bits of scrap 50mm x 50mm  box . 


[Image: P1100454_zpsf2k3ekaa.jpg]


Rob
Reply
Thanks given by: aRM
good job rob
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
(10-24-2015, 12:35 PM)RobWilson. Wrote: Knocked up a cable tie holder from a few bits of scrap 50mm x 50mm  box . 

Rob

Smiley-signs107

I thought I was doing well to have them sorted into individual ZipLoc bags, all the bags in one box and knew where the box was most of the time.

Arvid
Reply
Thanks given by:
Finally was able to do some work in the garage today. Started working on my parts for a work stop for the mill. Got most ops done  ran out of gas... To finish up all I gota do is cut slots  in all clamp block  sliders. . Cut the hardware to proper lengths. Put a finish on the parts, than modify  mill vice vice to accommodate the set up.   Was tired of using a make shift work stop figured this was 2nd worth spending the time on the new mill.


Attached Files Thumbnail(s)
           
Reply
Thanks given by:
Lookin good Kenny!
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
FINALLY wired up the welder outlet yesterday. No pics, you seen one outlet hanging off the side of a breaker panel, you've seen them all.

Tonite I started up another long needed project out of that 1/2" square tubing I picked up a few months ago. Pic shows the pieces cut up, we'll see if anyone can figure out what it's going to be when it grows up. If it's not raining tomorrow I'll get it finished.

[Image: stock.jpg]

Any guesses?
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
(10-25-2015, 09:48 PM)Vinny Wrote: [Image: stock.jpg]

Any guesses?

Chin

Chronograph sky screen bracket?   17428

That's what I made mine from anyway...   Rotfl
Willie
Reply
Thanks given by:
My money's on a Welding Cart
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
My belated birthday present to me, from me  Drinks

   
   
   

Have the cable run to the board and I'll finish the wire up tomorrow, single phase 15A dedicated circuit with a combination MCB/RCD for protection.

The lights are going to get lifted and I will probably end up swapping them over to a lower profile.  My back is really going to love not having to crawl around under cars Big Grin
Hunting American dentists since 2015.
Reply
Thanks given by:
Wow, that looks like a tight fit, height wise. Sweat

Ed
Reply
Thanks given by:




Users browsing this thread: 16 Guest(s)