Todays Project - What did you do today?
Very clean layout. I like it. Graemlin
Willie
Reply
Thanks given by:
It's alive! I'm still waiting on the sensor connector. Now UPS is saying it'll be here Tuesday instead of Monday. Bash

Ed

   
Reply
Thanks given by:
I finished the mounting block for the mini lathe tachometer. I replaced the plastic mount for the chuck guard that came with the lathe with an aluminum one that has a 1/4-20 tapped hole for mounting the tachometer bracket. The cavity in the plastic block housed a micro-switch to disable the motor driver when the chuck guard was not engaged. That's one of the first things I got rid of when I first got the lathe.

Ed

Original mounting block:

         

Replacement block:

         
Reply
Thanks given by:
Mocked up the mounting scheme for the tachometer. Looks good so I can convert it into steel.  Big Grin

Ed

   
Reply
Thanks given by:
Nice! Cool
Willie
Reply
Thanks given by: EdK
Got the magnets mounted for testing. I still need to make a holder/bracket for the Hall effect sensor.

Ed

   
Reply
Thanks given by:
(11-26-2023, 06:08 PM)EdK Wrote: Mocked up the mounting scheme for the tachometer. Looks good so I can convert it into steel.  Big Grin

Ed

Why bother?  It's not like it will be subject to much force.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
(11-28-2023, 07:18 AM)rleete Wrote:
(11-26-2023, 06:08 PM)EdK Wrote: Mocked up the mounting scheme for the tachometer. Looks good so I can convert it into steel.  Big Grin

Ed

Why bother?  It's not like it will be subject to much force.

Plastic threads don't work so well, in my experience.  Smiley-gen163
But, "To each his own."

Ed
Reply
Thanks given by:
Any worry about the magnets flying off at high speed?
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop  |  the nobucks boutique
Reply
Thanks given by:
(11-28-2023, 11:48 AM)Vinny Wrote: Any worry about the magnets flying off at high speed?

Just relocate the chuck shield to the other end of the headstock. Big Grin
Willie
Reply
Thanks given by:




Users browsing this thread: 23 Guest(s)