Harrison L5 lathe rebuild
Now that's a sexy lathe. Yikes

Ed
Reply
Thanks given by:
Why Thank You Ed Big Grin Rotfl

Cheers Mick.
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
The pictures do not do the lathe justice
Micks attention to detail is a credit to him
John
Reply
Thanks given by:
brill ThumbsupThumbsup
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
Looks really great Mick Thumbsup Worthy
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Stunning rebuild, better than new, and a quality machine too!
Excellent work!
Phil
Man who say it cannot be done should not disturb man doing it! https://www.youtube.com/user/philhermetic/videos?
Reply
Thanks given by:
Hi Lads , got some more done with the lathe, its looking like a lathe again now , just finishing bits to fit then a good check over and adjust this that and the other, test then probably re adjust things.
This is what it looks like now, still the end covers to fit , that horrible old maroon bakalite forward reverse knob for the power feed needs replaced and the screw cutting badges still to be done and the steadies , collet chuck etc to clean and paint, coolant hose.

[Image: Harrisonnearlydone001.jpg]

[Image: Harrisonnearlydone002.jpg]

[Image: Harrisonnearlydone003.jpg]

[Image: Harrisonnearlydone007.jpg]

[Image: Harrisonnearlydone008.jpg]

[Image: Harrisonnearlydone009.jpg]

[Image: Harrisonnearlydone010.jpg]

[Image: Harrisonnearlydone012.jpg]

[Image: Harrisonnearlydone013.jpg]

Not long until the first swarf hits the tray now !

Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
Very nice Mick. It probably looks better than it did right from the factory.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Gorgeous, just plain gorgeous, such a beautiful machine.
tackit, proud to be a member of MetalworkingFun Forum since May 2014.
Reply
Thanks given by:
You have done a beautiful job on this lathe, as nice as I've ever seen.

Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)