The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Machinist Calc Pro

Thread Modes
Machinist Calc Pro
TOM REED Offline
Junior
****
Posts: 266
Threads: 23
Joined: Feb 2012
Location: OLDS, ALBERTA
#1
08-30-2012, 11:29 PM (This post was last modified: 09-14-2012, 09:43 AM by DaveH.)
Here we go again too much time at home, I have been thinking about if I am smart enough to use one of these or not and had been contemplating buying one for a few months, found today fairly reasonable on E-BAY so next week when it arrives I will again get a thorough chewing out.
tom

http://www.ebay.ca/itm/200762876109?ssPa...1497.l2649
Logan 10x26" lathe
SIEG 12x40" lathe
RongFU 45 clone mill
6" import band saw
Baldor Grinder
thousand of tools+tooling pieces 40 yrs of collecting
Reply
Thanks given by:


Messages In This Thread
Machinist Calc Pro - by TOM REED - 08-30-2012, 11:29 PM
RE: MACHINIST CALC PRO - by PixMan - 08-31-2012, 06:35 AM
RE: MACHINIST CALC PRO - by TOM REED - 09-05-2012, 08:39 PM
RE: MACHINIST CALC PRO - by EdK - 09-06-2012, 06:03 AM
RE: MACHINIST CALC PRO - by Highpower - 09-06-2012, 07:01 AM
RE: MACHINIST CALC PRO - by TOM REED - 09-06-2012, 10:03 AM



Users browsing this thread: 1 Guest(s)