basic lathe tooling questions for new lathe

Hello There, Guest! Register

Thread Modes

basic lathe tooling questions for new lathe

f350ca Offline

Offline

Senior

Posts: 3,002
Threads: 51
Joined: Apr 2012
Location: Ontario

#18

04-08-2012, 12:21 AM

Steve, get your shaper working, it will cut dovetails in just about anything.

[Image: IMGP1173.JPG]

[Image: IMGP1173.JPG]

Free advice is worth exactly what you payed for it.
Greg

Reply

« Next Oldest | Next Newest »

Messages In This Thread

basic lathe tooling questions for new lathe - by candiamel - 04-03-2012, 01:54 PM

RE: basic lathe tooling questions for new lathe - by TOM REED - 04-03-2012, 02:20 PM

RE: basic lathe tooling questions for new lathe - by DaveH - 04-03-2012, 02:46 PM

RE: basic lathe tooling questions for new lathe - by doubleboost - 04-03-2012, 04:04 PM

RE: basic lathe tooling questions for new lathe - by stevec - 04-05-2012, 07:35 PM

RE: basic lathe tooling questions for new lathe - by doubleboost - 04-07-2012, 04:44 PM

RE: basic lathe tooling questions for new lathe - by stevec - 04-07-2012, 04:57 PM

RE: basic lathe tooling questions for new lathe - by PixMan - 04-05-2012, 06:44 PM

RE: basic lathe tooling questions for new lathe - by Mayhem - 04-05-2012, 09:22 PM

RE: basic lathe tooling questions for new lathe - by EdK - 04-06-2012, 06:18 PM

RE: basic lathe tooling questions for new lathe - by candiamel - 04-06-2012, 08:47 PM

RE: basic lathe tooling questions for new lathe - by f350ca - 04-06-2012, 09:51 PM

RE: basic lathe tooling questions for new lathe - by EdK - 04-07-2012, 11:59 AM

RE: basic lathe tooling questions for new lathe - by DaveH - 04-07-2012, 05:15 PM

RE: basic lathe tooling questions for new lathe - by doubleboost - 04-07-2012, 05:27 PM

RE: basic lathe tooling questions for new lathe - by TOM REED - 04-07-2012, 08:01 PM

RE: basic lathe tooling questions for new lathe - by EdK - 04-07-2012, 08:03 PM

RE: basic lathe tooling questions for new lathe - by TOM REED - 04-08-2012, 01:02 PM

RE: basic lathe tooling questions for new lathe - by f350ca - 04-08-2012, 12:21 AM

RE: basic lathe tooling questions for new lathe - by stevec - 04-08-2012, 06:03 AM

Users browsing this thread: 1 Guest(s)