06-29-2013, 08:52 PM
(06-29-2013, 02:54 PM)EdK Wrote: Luckily those set screws are all OK.
Ed
Ahhh, but I'll bet you haven't tried tightening them down on a tool yet, am I right?
The last batch I got from CDCO the hex rounded out in half of them on the first tightening. Now I just bin them straight out of the box and keep a large bag of set screws and studs on hand from McMaster as replacements.
I also chase all the threads in the holders before installing the new hardware. It's like a rock quarry down in those holes.
tools4cheap is looking better all the time.
Willie