boring bar inserts

Hello There, Guest! Register

Thread Modes

boring bar inserts

dallen Offline

Offline

Senior

Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma

#5

07-26-2013, 08:14 AM

knowing that I have the correct inserts that fit the bar and not wanting to spend 12 dollars in shipping for a 3 dollar chip breaker, I just took on of the tpg 222 inserts I have and turned it upside down and clamped it on top of the 322, there is no hole in the bar for a shim screw.

DA

dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue

Tongue

Reply

« Next Oldest | Next Newest »

Messages In This Thread

boring bar inserts - by dallen - 07-24-2013, 08:18 PM

RE: boring bar inserts - by EdK - 07-25-2013, 05:08 AM

RE: boring bar inserts - by stevec - 07-26-2013, 06:05 AM

RE: boring bar inserts - by dallen - 07-25-2013, 08:44 AM

RE: boring bar inserts - by dallen - 07-26-2013, 08:14 AM

RE: boring bar inserts - by PixMan - 07-27-2013, 08:19 AM

RE: boring bar inserts - by Rickabilly - 08-23-2013, 07:54 AM

RE: boring bar inserts - by EdK - 07-27-2013, 08:48 AM

RE: boring bar inserts - by PixMan - 07-27-2013, 02:41 PM

RE: boring bar inserts - by Rickabilly - 08-23-2013, 07:33 AM

RE: boring bar inserts - by dallen - 08-23-2013, 09:16 AM

RE: boring bar inserts - by Rickabilly - 08-23-2013, 11:30 AM

Users browsing this thread: 1 Guest(s)