Centering Over Round Piece
#4
(09-04-2013, 12:43 PM)PixMan Wrote: I find it's more accurate to use a dial test indicator on a long arm. You might not be able to reach the tangent point of a 1/5" radius with one of those.

Ken,

That's my concern also.

My first thought was to use a dial indicator but how do you keep the contact point in line with the axis of the mill spindle? 17428

Ed
Reply
Thanks given by:


Messages In This Thread
Centering Over Round Piece - by EdK - 09-04-2013, 11:51 AM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:10 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 12:43 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 12:56 PM
RE: Centering Over Round Piece - by dallen - 09-04-2013, 03:45 PM
RE: Centering Over Round Piece - by EdK - 09-04-2013, 04:01 PM
RE: Centering Over Round Piece - by Highpower - 09-04-2013, 08:17 PM
RE: Centering Over Round Piece - by TomG - 09-04-2013, 10:56 PM
RE: Centering Over Round Piece - by PixMan - 09-04-2013, 11:21 PM
RE: Centering Over Round Piece - by EdK - 09-05-2013, 08:30 AM



Users browsing this thread: 1 Guest(s)