The old saying after the first prototype the rest is easy. After hassles
with flebay and high prices of monoset collets for my mill. I shall repourpose junk from the junk bin. This one will be for 3/8 end mill which
I tapped for an allen set screw. Then I had to chuck a chuck cause
my table chuck I build is too big . Then I couldnt find a true 3/8 reamer
so i turned a true 3/8 round stuck it in the shaper and made my own
ream worked well, and so well when I put a end mill in this collet it pops
when I take it out _ a sucktion pop and its right on.
with flebay and high prices of monoset collets for my mill. I shall repourpose junk from the junk bin. This one will be for 3/8 end mill which
I tapped for an allen set screw. Then I had to chuck a chuck cause
my table chuck I build is too big . Then I couldnt find a true 3/8 reamer
so i turned a true 3/8 round stuck it in the shaper and made my own
ream worked well, and so well when I put a end mill in this collet it pops
when I take it out _ a sucktion pop and its right on.
big job, proud to be a member of MetalworkingFun since Jun 2012.