MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Drilling A Hole In A Ball

Thread Modes
Help Drilling A Hole In A Ball
EdK Offline
Whipping Boy
*******
Posts: 8,771
Threads: 316
Joined: Feb 2012
Location: Arizona/Minnesota
#22
11-15-2013, 01:17 PM
I already had the aluminum tubing I had gotten for free with a 3/8" thick wall so it was a no-brainer to build that one rather than reinvent the wheel.

Ed
Reply
Thanks given by:


Messages In This Thread
Drilling A Hole In A Ball - by EdK - 11-08-2013, 07:31 AM
RE: Drilling A Hole In A Ball - by TomG - 11-08-2013, 07:46 AM
RE: Drilling A Hole In A Ball - by EdK - 11-08-2013, 08:09 AM
RE: Drilling A Hole In A Ball - by krv3000 - 11-08-2013, 07:37 PM
RE: Drilling A Hole In A Ball - by stevec - 11-08-2013, 09:55 PM
RE: Drilling A Hole In A Ball - by EdK - 11-09-2013, 09:58 AM
RE: Drilling A Hole In A Ball - by dnavaille - 11-09-2013, 07:06 PM
RE: Drilling A Hole In A Ball - by EdK - 11-09-2013, 07:10 PM
RE: Drilling A Hole In A Ball - by awemawson - 11-10-2013, 07:27 AM
RE: Drilling A Hole In A Ball - by TomG - 11-09-2013, 07:56 PM
RE: Drilling A Hole In A Ball - by sasquatch - 11-10-2013, 07:19 PM
RE: Drilling A Hole In A Ball - by EdK - 11-11-2013, 07:09 AM
RE: Drilling A Hole In A Ball - by big job - 11-11-2013, 08:00 AM
RE: Drilling A Hole In A Ball - by EdK - 11-11-2013, 08:42 AM
RE: Drilling A Hole In A Ball - by stevec - 11-11-2013, 08:09 PM
RE: Drilling A Hole In A Ball - by EdK - 11-12-2013, 06:55 AM
RE: Drilling A Hole In A Ball - by PixMan - 11-14-2013, 07:20 PM
RE: Drilling A Hole In A Ball - by EdK - 11-15-2013, 07:10 AM
RE: Drilling A Hole In A Ball - by f350ca - 11-15-2013, 10:52 AM
RE: Drilling A Hole In A Ball - by EdK - 11-15-2013, 01:14 PM
RE: Drilling A Hole In A Ball - by TomG - 11-15-2013, 11:10 AM
RE: Drilling A Hole In A Ball - by EdK - 11-15-2013, 01:17 PM
RE: Drilling A Hole In A Ball - by wrustle - 11-15-2013, 05:23 PM
RE: Drilling A Hole In A Ball - by EdK - 11-15-2013, 05:46 PM



Users browsing this thread: 2 Guest(s)