Looking for input/help on the Pro Tram System from Edge Technologies
#8
I'd use a pro tram if I had one but it does measure over only a relatively short distance. As others have said a single gauge on a longer arm is likely to be more accurate if time consuming. This is after all how it was done until the pro tram appeared, in fact a guy I used to work with just used a bent rod and cigarette papers!
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:


Messages In This Thread
RE: Looking for input/help on the Pro Tram System from Edge Technologies - by Arbalest - 12-21-2013, 04:10 PM



Users browsing this thread: 2 Guest(s)