|
Douglas shaper in slow motion
|
10-01-2014, 05:45 AM
(09-30-2014, 03:52 PM)stevec Wrote: Shawn, is the retract stroke the same speed as the cutting stroke? I couldn't tell. Is that a carbide insert cutting tool? If so,tsk. tsk. Here's an explain action of the mechanism for those who are interested. https://youtube.com/watch?v=Jx5nOn0tf_k
Bigbadbugga, proud to be a member of MetalworkingFun Forum since Aug 2014.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:02 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 03:13 PM
RE: Douglas shaper in slow motion - by EdK - 09-30-2014, 03:25 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:42 PM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:47 PM
RE: Douglas shaper in slow motion - by TomG - 09-30-2014, 05:45 PM
RE: Douglas shaper in slow motion - by stevec - 09-30-2014, 03:52 PM
RE: Douglas shaper in slow motion - by Bigbadbugga - 10-01-2014, 05:45 AM
RE: Douglas shaper in slow motion - by Shawn - 09-30-2014, 03:58 PM
RE: Douglas shaper in slow motion - by f350ca - 09-30-2014, 04:55 PM
RE: Douglas shaper in slow motion - by Artie - 09-30-2014, 10:14 PM
RE: Douglas shaper in slow motion - by PixMan - 09-30-2014, 10:54 PM
RE: Douglas shaper in slow motion - by Shawn - 10-01-2014, 12:59 AM
RE: Douglas shaper in slow motion - by stevec - 10-01-2014, 07:44 AM
|
