Help Edgewick Light Type Lathe help
#24
Terry you are totally right, that is the handle to engage or disengage the sliding gears.  I now have feed speeds available to me.

THank you so much for all the input guys, its been great to talk to you all.

Cheers, Dan.

[Image: 009_zpsfa883086.jpg]
Reply
Thanks given by:


Messages In This Thread
Edgewick Light Type Lathe help - by Dan Boy - 01-25-2015, 04:11 AM
RE: Edgewick Light Type Lathe help - by tekfab - 01-25-2015, 05:21 AM
RE: Edgewick Light Type Lathe help - by Dan Boy - 01-25-2015, 07:21 AM
RE: Edgewick Light Type Lathe help - by tekfab - 01-25-2015, 08:02 AM
RE: Edgewick Light Type Lathe help - by stevec - 01-25-2015, 09:01 AM
RE: Edgewick Light Type Lathe help - by Dan Boy - 01-25-2015, 09:30 AM
RE: Edgewick Light Type Lathe help - by EdK - 01-25-2015, 09:39 AM
RE: Edgewick Light Type Lathe help - by terrywerm - 01-25-2015, 10:09 AM
RE: Edgewick Light Type Lathe help - by stevec - 01-25-2015, 07:45 PM
RE: Edgewick Light Type Lathe help - by tekfab - 01-25-2015, 10:27 AM
RE: Edgewick Light Type Lathe help - by Dr Stan - 01-25-2015, 10:29 AM
RE: Edgewick Light Type Lathe help - by Dan Boy - 01-25-2015, 03:17 PM
RE: Edgewick Light Type Lathe help - by DaveH - 01-25-2015, 03:55 PM
RE: Edgewick Light Type Lathe help - by hermetic - 01-25-2015, 04:00 PM
RE: Edgewick Light Type Lathe help - by hermetic - 01-25-2015, 04:04 PM
RE: Edgewick Light Type Lathe help - by hermetic - 01-25-2015, 04:13 PM
RE: Edgewick Light Type Lathe help - by hermetic - 01-25-2015, 04:38 PM
RE: Edgewick Light Type Lathe help - by hermetic - 01-25-2015, 04:50 PM
RE: Edgewick Light Type Lathe help - by Dan Boy - 01-25-2015, 05:06 PM
RE: Edgewick Light Type Lathe help - by Mayhem - 01-25-2015, 07:48 PM
RE: Edgewick Light Type Lathe help - by terrywerm - 01-26-2015, 01:51 AM
RE: Edgewick Light Type Lathe help - by Dan Boy - 01-26-2015, 01:58 AM
RE: Edgewick Light Type Lathe help - by terrywerm - 01-26-2015, 07:36 AM
RE: Edgewick Light Type Lathe help - by tekfab - 01-26-2015, 07:46 AM
RE: Edgewick Light Type Lathe help - by hermetic - 01-26-2015, 02:52 PM



Users browsing this thread: 3 Guest(s)