Form tools on the lathe

Hello There, Guest! Register

Thread Modes

Form tools on the lathe

dallen Offline

Offline

Senior

Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma

#12

01-29-2015, 09:15 AM

(01-29-2015, 06:31 AM)Mayhem Wrote: After melting several of my wife's fridge magnets, I decided to give up on that route. The temp crayons look interesting.

reason I have a ceramic one stuck to the side of my gas forge, pull the part out touch it if it sticks its back into the heat for a minute or two longer.

DA

dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue

Tongue

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Form tools on the lathe - by Shawn - 01-28-2015, 05:40 PM

RE: Form tools on the lathe - by Shawn - 01-28-2015, 05:46 PM

RE: Form tools on the lathe - by Shawn - 01-28-2015, 06:55 PM

RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:10 PM

RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:20 PM

RE: Form tools on the lathe - by dallen - 01-28-2015, 07:42 PM

RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:50 PM

RE: Form tools on the lathe - by Highpower - 01-28-2015, 11:56 PM

RE: Form tools on the lathe - by Shawn - 01-28-2015, 07:55 PM

RE: Form tools on the lathe - by DaveH - 01-28-2015, 07:57 PM

RE: Form tools on the lathe - by Mayhem - 01-29-2015, 06:31 AM

RE: Form tools on the lathe - by dallen - 01-29-2015, 09:15 AM

RE: Form tools on the lathe - by vtsteam - 01-29-2015, 11:15 AM

RE: Form tools on the lathe - by Baron - 02-15-2015, 04:54 PM

RE: Form tools on the lathe - by Shawn - 02-16-2015, 11:10 PM

Users browsing this thread: 1 Guest(s)