Fixing a Leaky RF-45 Mill Head - Grizzly G0519
#75
(05-15-2012, 12:41 AM)TOM REED Wrote: Very nice documentation both your and Ed's work,m just a couple of comments you should always liberally grease all lip type seals upon installation which you did, also I doubt you will ever have a problem with the paint you used, I used to paint the interior of race engines that I built with Rustoleum red primer which is fish oil based paint. I never ever had a problem with the paint other than occasionally getting a drop in the wrong place eg lifter bores and having to remove it. Sure helps keep things clean on the inside of an engine or gearbox, also note lots of the gearboxes in todays large trucks are painted with what apears to be the same paint. tom

+1 with Rustoleum Red Primer on the interior of several small block Chevrolet engines and never a problem that was paint related.
Reply
Thanks given by:


Messages In This Thread
RE: Fixing a Leaky RF-45 Mill Head - Grizzly G0519 - by arvidj - 05-15-2012, 06:46 PM



Users browsing this thread: 1 Guest(s)