MetalworkingFun Forum › Machining › General Metalworking Discussion v
Randall Cox Open Six

Thread Modes
Randall Cox Open Six
arvidj Offline
Junior
****
Posts: 726
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
The following 2 users Like arvidj's post:
Highpower (02-23-2015), EdK (02-23-2015)
#7
02-23-2015, 09:51 AM
Wow!!

What an educational opportunity for many people who seldom venture under the hood of their car ... "This is what is going on under that big piece of decorative plastic you see when you open the hood."
Reply
Thanks given by:


Messages In This Thread
Randall Cox Open Six - by TomG - 02-22-2015, 10:26 AM
RE: Randall Cox Open Six - by NormanV - 02-22-2015, 11:28 AM
RE: Randall Cox Open Six - by hermetic - 02-22-2015, 11:40 AM
RE: Randall Cox Open Six - by Highpower - 02-22-2015, 12:24 PM
RE: Randall Cox Open Six - by Roadracer_Al - 02-22-2015, 01:04 PM
RE: Randall Cox Open Six - by Mayhem - 02-23-2015, 07:17 AM
RE: Randall Cox Open Six - by arvidj - 02-23-2015, 09:51 AM
RE: Randall Cox Open Six - by EdK - 02-23-2015, 05:28 PM
RE: Randall Cox Open Six - by mike-sid - 02-23-2015, 05:40 PM
RE: Randall Cox Open Six - by Dr Stan - 02-23-2015, 06:50 PM



Users browsing this thread: 1 Guest(s)