Ok, what went wrong?
#20
I'm yet to use a plasma cutter, don't know much about them at all so i'm sure i could make a cut look much worse than yours Vinny! Looks like a cut with an oxy torch that had a blocked tip. Does surface rust have an effect on plasma cutting?
Lathe (n); a machine tool used in the production of milling machine components.

Milling Machine (n); a machine tool used in the production of lathe components.
Reply
Thanks given by:


Messages In This Thread
Ok, what went wrong? - by Vinny - 06-01-2015, 05:05 PM
RE: Ok, what went wrong? - by dallen - 06-01-2015, 05:09 PM
RE: Ok, what went wrong? - by Vinny - 06-01-2015, 05:21 PM
RE: Ok, what went wrong? - by dallen - 06-01-2015, 05:36 PM
RE: Ok, what went wrong? - by Vinny - 06-01-2015, 05:39 PM
RE: Ok, what went wrong? - by dallen - 06-01-2015, 05:54 PM
RE: Ok, what went wrong? - by f350ca - 06-01-2015, 07:13 PM
RE: Ok, what went wrong? - by PixMan - 06-01-2015, 07:15 PM
RE: Ok, what went wrong? - by Mayhem - 06-02-2015, 07:07 AM
RE: Ok, what went wrong? - by EdK - 06-02-2015, 04:41 PM
RE: Ok, what went wrong? - by stevec - 06-02-2015, 04:59 PM
RE: Ok, what went wrong? - by EdK - 06-02-2015, 05:12 PM
RE: Ok, what went wrong? - by EdK - 06-01-2015, 07:57 PM
RE: Ok, what went wrong? - by Vinny - 06-01-2015, 08:33 PM
RE: Ok, what went wrong? - by EdK - 06-02-2015, 07:05 AM
RE: Ok, what went wrong? - by Vinny - 06-02-2015, 02:29 PM
RE: Ok, what went wrong? - by awemawson - 06-02-2015, 01:43 AM
RE: Ok, what went wrong? - by trevatxtal - 06-02-2015, 02:35 AM
RE: Ok, what went wrong? - by oldgoaly - 06-04-2015, 06:55 AM
RE: Ok, what went wrong? - by Pete O - 06-04-2015, 07:14 AM
RE: Ok, what went wrong? - by Vinny - 06-04-2015, 04:04 PM
RE: Ok, what went wrong? - by Vinny - 06-04-2015, 04:10 PM
RE: Ok, what went wrong? - by DaveH - 06-04-2015, 04:52 PM
RE: Ok, what went wrong? - by Vinny - 06-06-2015, 06:38 PM
RE: Ok, what went wrong? - by oldskoolron - 10-24-2016, 08:12 PM



Users browsing this thread: 1 Guest(s)