07-26-2015, 09:28 PM
Wongster;
problem with using shellac to hold the parts with would be getting them aligned properly.
one of the modern high strength glues would probably work better, do the parts have to be machined on both sides?.
problem with using shellac to hold the parts with would be getting them aligned properly.
one of the modern high strength glues would probably work better, do the parts have to be machined on both sides?.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!