|
Help Cutting a flute on a tap
|
09-13-2015, 08:00 AM
I've made the odd tap - only when I really had to. They are a little more tricky than it seems the flutes are straight forward. I used an ordinary end mill and went straight in from the side so it doesn't look like a flute in a tap sense. The tricky bit is the clearance from the cutting edge again I just milled it. Not perfect by any means.
 DaveH |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Cutting a flute on a tap - by ieezitin - 09-12-2015, 08:00 PM
RE: Cutting a flute on a tap - by Hopefuldave - 09-13-2015, 07:33 AM
RE: Cutting a flute on a tap - by DaveH - 09-13-2015, 08:00 AM
RE: Cutting a flute on a tap - by TomG - 09-14-2015, 06:45 AM
RE: Cutting a flute on a tap - by ieezitin - 09-14-2015, 04:52 PM
RE: Cutting a flute on a tap - by trevatxtal - 09-15-2015, 02:43 AM
RE: Cutting a flute on a tap - by ieezitin - 09-20-2015, 10:52 AM
RE: Cutting a flute on a tap - by DaveH - 09-20-2015, 11:26 AM
RE: Cutting a flute on a tap - by Highpower - 09-20-2015, 11:38 AM
RE: Cutting a flute on a tap - by RobWilson - 09-20-2015, 12:15 PM
RE: Cutting a flute on a tap - by Mayhem - 09-20-2015, 05:33 PM
RE: Cutting a flute on a tap - by TomG - 09-20-2015, 07:58 PM
RE: Cutting a flute on a tap - by Hopefuldave - 09-25-2015, 06:22 PM
|
