|
Rod Bender Plans
|
|
12-27-2015, 08:06 PM
I've had this one for years Ed. It has Vee'd jaws for round stock and different dies for varying radius bends. Bends 1/2 round effortlessly, think its 1/4 x 4 flat it will bend. I have it mounted on a 2 inch square tube that goes into a receiver on one of the columns of the shop.
![[Image: 2910280.jpg?_v=5a94e708-b43a-47fc-b9d2-56110847a5a6]](http://images11.palcdn.com/hlr-system/WebPhotos/29/291/2910/2910280.jpg?_v=5a94e708-b43a-47fc-b9d2-56110847a5a6)
Free advice is worth exactly what you payed for it.
Greg Thanks given by: EdK
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Rod Bender Plans - by EdK - 12-27-2015, 04:56 PM
RE: Rod Bender Plans - by DaveH - 12-27-2015, 05:31 PM
RE: Rod Bender Plans - by EdK - 12-27-2015, 05:44 PM
RE: Rod Bender Plans - by f350ca - 12-27-2015, 08:06 PM
RE: Rod Bender Plans - by Highpower - 12-27-2015, 10:02 PM
RE: Rod Bender Plans - by f350ca - 12-28-2015, 12:58 AM
RE: Rod Bender Plans - by Highpower - 12-28-2015, 05:19 PM
RE: Rod Bender Plans - by wawoodman - 12-28-2015, 07:26 PM
RE: Rod Bender Plans - by Vinny - 12-28-2015, 08:18 PM
RE: Rod Bender Plans - by aametalmaster - 01-28-2016, 08:24 PM
|
