Hold square bar in a 3 jaw chuck
#6
That's a cool idea Dave,

I can see where that would come in handy!

Thanks for the tip.Smiley-signs107

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
Hold square bar in a 3 jaw chuck - by DaveH - 02-15-2012, 09:39 PM
RE: Hold square bar in a 3 jaw chuck - by PixMan - 02-15-2012, 10:45 PM
RE: Hold square bar in a 3 jaw chuck - by DaveH - 02-15-2012, 11:14 PM
RE: Hold square bar in a 3 jaw chuck - by RobWilson - 02-19-2012, 06:00 PM
RE: Hold square bar in a 3 jaw chuck - by ETC57 - 02-25-2012, 11:13 AM
RE: Hold square bar in a 3 jaw chuck - by rleete - 03-04-2012, 12:55 PM
RE: Hold square bar in a 3 jaw chuck - by DaveH - 03-04-2012, 01:01 PM
RE: Hold square bar in a 3 jaw chuck - by B34VD - 03-05-2012, 05:27 PM
RE: Hold square bar in a 3 jaw chuck - by DaveH - 03-05-2012, 05:33 PM
RE: Hold square bar in a 3 jaw chuck - by Mayhem - 03-06-2012, 06:59 AM
RE: Hold square bar in a 3 jaw chuck - by DaveH - 03-06-2012, 08:49 AM



Users browsing this thread: 1 Guest(s)