Good sources for learning basics/My basic Questions
|
Good sources for learning basics/My basic Questions
|
|
09-29-2020, 10:45 PM
I should point out that the broken plastic handwheel wasn't burned out of the mold. I used it as a pattern in a green sand mold, just as a test. It worked so well, I machined the thing and put it on the saw. Still using it.
Mike
If you can't get one, make one. Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Good sources for learning basics/My basic Questions - by coolhotdogguy - 09-28-2020, 01:02 PM
RE: Good sources for learning basics/My basic Questions - by rleete - 09-28-2020, 03:20 PM
RE: Good sources for learning basics/My basic Questions - by Dr Stan - 09-28-2020, 05:40 PM
RE: Good sources for learning basics/My basic Questions - by Dr Stan - 09-28-2020, 07:34 PM
RE: Good sources for learning basics/My basic Questions - by Hawkeye - 09-28-2020, 10:19 PM
RE: Good sources for learning basics/My basic Questions - by Dr Stan - 09-28-2020, 10:58 PM
RE: Good sources for learning basics/My basic Questions - by Highpower - 09-29-2020, 04:46 AM
RE: Good sources for learning basics/My basic Questions - by Dr Stan - 09-29-2020, 07:47 AM
RE: Good sources for learning basics/My basic Questions - by Hawkeye - 09-29-2020, 10:45 PM
RE: Good sources for learning basics/My basic Questions - by Dr Stan - 09-30-2020, 01:57 PM
|
