bandsaw refurb

[krv3000]

hi well the mane parts of the saw has bin panted and the gide wheels have bin cleaned and re greased i used spray on grease designed for bike change i had to pull the motor dawn as one of the Bering's was feeling ruff i replaced both of them and and while the motor was in bits i put two new terminals on it with sleeves the next bit is a bit of haw too before re-panted the motor i removed the label as this label is made out of aluminum foil. get a utility knife blade and just wame up the back of the plate that the label is on then carefully slide the knife blade under the label it will lift easily once you have a nuff to get hold of gently pull on the label and it will peel off once off be very carefully on the next bit the only thing that i have cum a cross that will remove the glue left on the back of a label is petrol as this dus not tack the print on the label. put sum in a container with a good fitting lid and let the label soak after a short time remove the label and the glue will be able to be wiped off then get sum double sided tape and put this on the back of the label then when the re-pant is dun you just reattach the label i remounted the saw back on to its base originally its riveted on but i have used 4 m4 counter sunk screws to put it back on with will post sum pics tonight