08-28-2012, 12:20 PM
(08-28-2012, 11:43 AM)TOM REED Wrote: now the gears are turnun. tom
Tom, that's good! Keep those gears lubricated.
![Big Grin Big Grin](http://www.metalworkingfun.com/images/smilies/biggrin.gif)
Whatever you use just make sure you have a means of adjusting the position of the beam on your unit. I stuck mine in the mill spindle (fresh out of the box) and spun it by hand, and it traced out a nice little circle on the table.
![Slaphead Slaphead](http://www.metalworkingfun.com/images/smilies/slaphead.gif)
Glad I didn't try to sight in any scopes with it...
![Rotfl Rotfl](http://www.metalworkingfun.com/images/smilies/rotfl.gif)
The 4 set screws around the head allowed me to get it centered up when I was finished though. Spin it in the spindle now, and the dot doesn't move a bit.
![Smile Smile](http://www.metalworkingfun.com/images/smilies/smile.gif)
Willie