12-09-2012, 07:15 PM
The pin placement was easy, bolted the lathe tool into the tool holder, ran the right size transfer punch, down through the pin bolt hole, marked the the lathe tool, then mill the slot on that mark.
jack
|
Flip Up Threading Tool
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Flip Up Threading Tool - by the penguin - 12-07-2012, 10:25 PM
RE: Flip Up Threading Tool - by EdK - 12-08-2012, 09:41 AM
RE: Flip Up Threading Tool - by doubleboost - 12-08-2012, 06:34 PM
RE: Flip Up Threading Tool - by dallen - 12-08-2012, 06:51 PM
RE: Flip Up Threading Tool - by Mayhem - 12-08-2012, 07:13 PM
RE: Flip Up Threading Tool - by sasquatch - 12-08-2012, 07:42 PM
RE: Flip Up Threading Tool - by DaveH - 12-09-2012, 06:35 AM
RE: Flip Up Threading Tool - by Sunset Machine - 12-09-2012, 12:55 PM
RE: Flip Up Threading Tool - by the penguin - 12-09-2012, 02:40 PM
RE: Flip Up Threading Tool - by stevec - 12-09-2012, 06:24 PM
RE: Flip Up Threading Tool - by the penguin - 12-09-2012, 07:15 PM
RE: Flip Up Threading Tool - by Sunset Machine - 12-10-2012, 09:12 AM
RE: Flip Up Threading Tool - by the penguin - 12-10-2012, 11:35 AM
RE: Flip Up Threading Tool - by Rickabilly - 07-24-2016, 09:36 AM
RE: Flip Up Threading Tool - by pepi - 07-24-2016, 10:14 PM
|
Users browsing this thread: 1 Guest(s)