MetalworkingFun Forum › Machining › Projects v
Paying the bills...

Thread Modes
Paying the bills...
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#14
12-21-2012, 01:13 PM
(12-21-2012, 01:02 PM)TomG Wrote: Thanks Dave, the handle came from McMaster Carr. Slaphead

But I did make the stainless latch mechanism. Happyyes

Tom

Very smart Tom Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
Paying the bills... - by TomG - 12-20-2012, 01:10 PM
RE: Paying the bills... - by dallen - 12-20-2012, 01:42 PM
RE: Paying the bills... - by EdK - 12-20-2012, 05:06 PM
RE: Paying the bills... - by ETC57 - 12-20-2012, 05:52 PM
RE: Paying the bills... - by Mayhem - 12-20-2012, 05:55 PM
RE: Paying the bills... - by TomG - 12-20-2012, 06:29 PM
RE: Paying the bills... - by sasquatch - 12-20-2012, 07:08 PM
RE: Paying the bills... - by TomG - 12-20-2012, 07:14 PM
RE: Paying the bills... - by f350ca - 12-20-2012, 08:15 PM
RE: Paying the bills... - by TomG - 12-20-2012, 08:55 PM
RE: Paying the bills... - by f350ca - 12-20-2012, 09:40 PM
RE: Paying the bills... - by DaveH - 12-21-2012, 12:43 PM
RE: Paying the bills... - by TomG - 12-21-2012, 01:02 PM
RE: Paying the bills... - by DaveH - 12-21-2012, 01:13 PM



Users browsing this thread: 1 Guest(s)