The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machinery › Milling Machines v
First Chips

Thread Modes
First Chips
Bill Gruby
Unregistered
 
#1
12-20-2012, 03:08 PM
My Clausing 8520 is finally up and running. Upgraded to a 1 HP motor when the 1/2 HP original would not run.

3/16 HSS 2 flute cutter 390 RPM .130 deep. I am a happy camper. Thumbsup

"Billy G" Big Grin


Attached Files Thumbnail(s)
       
Reply
Thanks given by:


Messages In This Thread
First Chips - by Bill Gruby - 12-20-2012, 03:08 PM
RE: First Chips - by PixMan - 12-20-2012, 05:55 PM
RE: First Chips - by stevec - 12-21-2012, 07:43 AM
RE: First Chips - by Mayhem - 12-20-2012, 05:58 PM
RE: First Chips - by Bill Gruby - 12-20-2012, 06:21 PM
RE: First Chips - by DaveH - 12-20-2012, 06:47 PM
RE: First Chips - by sasquatch - 12-20-2012, 07:14 PM
RE: First Chips - by Bill Gruby - 12-20-2012, 08:22 PM
RE: First Chips - by Bill Gruby - 12-21-2012, 07:58 AM
RE: First Chips - by DaveH - 12-21-2012, 12:34 PM
RE: First Chips - by stevec - 12-21-2012, 02:12 PM



Users browsing this thread: 1 Guest(s)