D.T.I fix
#1
hi all had sum time in me workshop today so i got on with this job in all the dti is in good order as you will see by the pics it needed a new back making so i had a rummage and got a nice bit of brass to do the job as you will see their is a hole in the part that will become the back this will be sorted out when the bracket gos on the back i marked out the disk then cut it out and ruff it out to shape then i put sum stock in me chuck and fast this off then with sum super glue and me running center stuck the disc to the stock then turned dawn the OD right pics


Attached Files Thumbnail(s)
                               
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
D.T.I fix - by krv3000 - 02-03-2013, 06:24 PM
RE: D.T.I fix - by Mayhem - 02-04-2013, 10:24 AM
RE: D.T.I fix - by Highpower - 02-04-2013, 02:08 PM
RE: D.T.I fix - by krv3000 - 02-05-2013, 05:10 PM
RE: D.T.I fix - by EdK - 02-05-2013, 07:57 PM
RE: D.T.I fix - by Bill Gruby - 02-05-2013, 08:23 PM
RE: D.T.I fix - by DaveH - 02-08-2013, 07:23 PM
RE: D.T.I fix - by krv3000 - 02-09-2013, 07:10 PM
RE: D.T.I fix - by ETC57 - 02-12-2013, 08:08 AM
RE: D.T.I fix - by krv3000 - 02-12-2013, 06:40 PM
RE: D.T.I fix - by sasquatch - 02-12-2013, 07:36 PM
RE: D.T.I fix - by Mayhem - 02-13-2013, 04:31 AM
RE: D.T.I fix - by EdK - 02-13-2013, 02:45 PM
RE: D.T.I fix - by DaveH - 02-14-2013, 03:09 PM
RE: D.T.I fix - by krv3000 - 02-16-2013, 04:35 PM



Users browsing this thread: 1 Guest(s)