MetalworkingFun Forum › Machinery › Lathes v
Soft Jaws

Thread Modes
Soft Jaws
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#9
03-18-2013, 03:56 PM
Mayhem, I have plenty of ash, this being still the heating season.
Tom, I would be less concerned about re-hardening them, they wouldn't be used at a high enough frequency to cause much wear.
I'm concerned about heating them to 1400°F for a ½ hr.
Also, would oxidation change them dimensionally? As inthey would no longer fit the chuck properly?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Soft Jaws - by stevec - 03-17-2013, 03:39 PM
RE: Soft Jaws - by krv3000 - 03-17-2013, 03:58 PM
RE: Soft Jaws - by EdK - 03-17-2013, 04:29 PM
RE: Soft Jaws - by Hopefuldave - 03-18-2013, 08:45 PM
RE: Soft Jaws - by f350ca - 03-17-2013, 08:09 PM
RE: Soft Jaws - by TomG - 03-17-2013, 08:20 PM
RE: Soft Jaws - by stevec - 03-18-2013, 08:05 AM
RE: Soft Jaws - by Mayhem - 03-18-2013, 09:46 AM
RE: Soft Jaws - by stevec - 03-24-2013, 07:05 AM
RE: Soft Jaws - by TomG - 03-18-2013, 10:15 AM
RE: Soft Jaws - by stevec - 03-18-2013, 03:56 PM
RE: Soft Jaws - by DaveH - 03-18-2013, 04:56 PM
RE: Soft Jaws - by TomG - 03-18-2013, 04:57 PM
RE: Soft Jaws - by DaveH - 03-18-2013, 05:32 PM
RE: Soft Jaws - by stevec - 03-24-2013, 09:20 AM
RE: Soft Jaws - by Mayhem - 03-24-2013, 09:26 AM
RE: Soft Jaws - by TomG - 03-24-2013, 09:33 AM
RE: Soft Jaws - by stevec - 03-24-2013, 09:49 AM
RE: Soft Jaws - by f350ca - 03-24-2013, 10:07 AM
RE: Soft Jaws - by stevec - 03-24-2013, 12:07 PM
RE: Soft Jaws - by EdK - 03-24-2013, 12:10 PM
RE: Soft Jaws - by DaveH - 03-24-2013, 03:27 PM
RE: Soft Jaws - by stevec - 03-24-2013, 05:11 PM



Users browsing this thread: 1 Guest(s)