The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machinery › Lathes v
24UNJ vs 24UN threads

Thread Modes
24UNJ vs 24UN threads
fullautomike
Unregistered
 
#1
04-12-2013, 08:12 PM
What did I do? I was going to make a 3/8 x 24 tpi threaded rod for a project, but the threads are not right! 17428 I was using a full profile laydown threading insert. I used a 16ER 24 UNJ VC29. I think I messed up by using 24UNJ. It should have been a 24UN what's the difference? What did I do??
Thanks
Reply
Thanks given by:


Messages In This Thread
24UNJ vs 24UN threads - by fullautomike - 04-12-2013, 08:12 PM
RE: 24UNJ vs 24UN threads - by wrustle - 04-12-2013, 10:16 PM
RE: 24UNJ vs 24UN threads - by wrustle - 04-13-2013, 12:28 PM
RE: 24UNJ vs 24UN threads - by the penguin - 04-13-2013, 11:16 AM
RE: 24UNJ vs 24UN threads - by fullautomike - 04-13-2013, 08:57 PM
RE: 24UNJ vs 24UN threads - by PixMan - 04-14-2013, 05:00 PM



Users browsing this thread: 1 Guest(s)