Milling machine coolant tray
#12
Thanks guys, it's good to get a bit of feed back on projects.
I was totally over making it by the time it was finished as it ended up a bigger job than I thought. The black sealer was the worse and just putting the main tray together after all the holes where drilled with the sealer took around 5 hours as the stuff ended up everywhere I looked and needed turps to get it off. It was on my hands for days as it stained, LOL

Mick,
When ever I make anything I try to aim for it to look factory. In the past I have shown mates things I have made and they haven't believed me, then I go and get some off cuts or something from in the shed that it was cut out of to convince them I made it.

Dave
Reply
Thanks given by:


Messages In This Thread
Milling machine coolant tray - by Dave J - 04-23-2013, 05:34 AM
RE: Milling machine coolant tray - by EdK - 04-23-2013, 05:51 AM
RE: Milling machine coolant tray - by Mayhem - 04-23-2013, 06:30 AM
RE: Milling machine coolant tray - by TomG - 04-23-2013, 08:22 AM
RE: Milling machine coolant tray - by Dave J - 04-23-2013, 08:54 AM
RE: Milling machine coolant tray - by Dave J - 04-23-2013, 09:04 AM
RE: Milling machine coolant tray - by DaveH - 04-23-2013, 02:16 PM
RE: Milling machine coolant tray - by Dave J - 04-27-2013, 03:22 AM
RE: Milling machine coolant tray - by Micktoon - 04-23-2013, 04:53 PM
RE: Milling machine coolant tray - by doubleboost - 04-23-2013, 04:59 PM
RE: Milling machine coolant tray - by monkers - 04-26-2013, 09:14 PM
RE: Milling machine coolant tray - by Dave J - 04-27-2013, 03:32 AM
RE: Milling machine coolant tray - by DaveH - 04-27-2013, 07:34 AM



Users browsing this thread: 1 Guest(s)