brass re-cycling !!
#12
(04-26-2013, 12:43 PM)f350ca Wrote: I'll give the cut off disks a try. Sounds less intimidating than smacking 60 pounds of red hot metal with the intent of shattering it.
Would have thought the bronze would plug up the disk, use them often on steel.

Bronze cuts very well with a 1mm disc
John
Reply
Thanks given by:


Messages In This Thread
brass re-cycling !! - by the artfull-codger - 04-23-2013, 04:16 PM
RE: brass re-cycling !! - by f350ca - 04-23-2013, 07:49 PM
RE: brass re-cycling !! - by the artfull-codger - 04-24-2013, 11:58 AM
RE: brass re-cycling !! - by f350ca - 04-24-2013, 01:33 PM
RE: brass re-cycling !! - by the artfull-codger - 04-24-2013, 02:26 PM
RE: brass re-cycling !! - by doubleboost - 04-24-2013, 03:50 PM
RE: brass re-cycling !! - by f350ca - 04-24-2013, 07:53 PM
RE: brass re-cycling !! - by the artfull-codger - 04-25-2013, 02:18 PM
RE: brass re-cycling !! - by doubleboost - 04-25-2013, 02:38 PM
RE: brass re-cycling !! - by the artfull-codger - 04-26-2013, 12:15 PM
RE: brass re-cycling !! - by f350ca - 04-26-2013, 12:43 PM
RE: brass re-cycling !! - by doubleboost - 04-26-2013, 02:23 PM



Users browsing this thread: 1 Guest(s)