|
sand cores
|
06-11-2013, 03:24 PM
(This post was last modified: 06-11-2013, 03:25 PM by the artfull-codger.)
showing the draught.JPG (Size: 28.3 KB / Downloads: 17)
showing the draught for the pattern, the pattern's just resting on the saw table & not being cut in 1/2 as it appears!!.Graham.
the artfull-codger, proud to be a member of MetalworkingFun Forum since Feb 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
sand cores - by the artfull-codger - 05-27-2013, 03:12 PM
RE: sand cores - by doubleboost - 05-27-2013, 03:19 PM
RE: sand cores - by the artfull-codger - 05-27-2013, 03:46 PM
RE: sand cores - by the artfull-codger - 05-28-2013, 01:07 PM
RE: sand cores - by DaveH - 06-01-2013, 11:37 AM
RE: sand cores - by the artfull-codger - 06-03-2013, 04:41 PM
RE: sand cores - by the artfull-codger - 06-03-2013, 05:01 PM
RE: sand cores - by the artfull-codger - 06-03-2013, 05:13 PM
RE: sand cores - by the artfull-codger - 06-09-2013, 03:53 PM
RE: sand cores - by DaveH - 06-10-2013, 02:59 PM
RE: sand cores - by the artfull-codger - 06-11-2013, 03:24 PM
|
