MetalworkingFun Forum › Machining › Projects v
Dividing Head

Thread Modes
Dividing Head
Bill Gruby
Unregistered
 
#9
07-24-2013, 04:35 PM
(07-24-2013, 03:22 PM)marfaguy Wrote: Just got through watching part 2. Very interesting. I plan on paying very close attention.
John, the wax stuff you use to make fillets with. If you don't mine me asking, what's it called?

Part 2 ? Did I miss a post with a video part?

"Billy G"
Reply
Thanks given by:


Messages In This Thread
Dividing Head - by doubleboost - 07-20-2013, 03:22 PM
RE: Deviding Head - by DaveH - 07-20-2013, 04:23 PM
RE: Dividing Head - by EdK - 07-20-2013, 05:51 PM
RE: Dividing Head - by Highpower - 07-21-2013, 09:18 AM
RE: Dividing Head - by Bill Gruby - 07-21-2013, 09:20 AM
RE: Dividing Head - by krv3000 - 07-23-2013, 04:30 PM
RE: Dividing Head - by marfaguy - 07-24-2013, 03:22 PM
RE: Dividing Head - by doubleboost - 07-24-2013, 03:54 PM
RE: Dividing Head - by Bill Gruby - 07-24-2013, 04:35 PM
RE: Dividing Head - by marfaguy - 07-25-2013, 01:56 PM
RE: Dividing Head - by the artfull-codger - 07-25-2013, 02:08 PM
RE: Dividing Head - by EdK - 07-25-2013, 05:33 PM
RE: Dividing Head - by chucketn - 08-10-2013, 07:48 AM



Users browsing this thread: 1 Guest(s)