MetalworkingFun Forum › Machining › Projects v
Making A Spring

Thread Modes
Making A Spring
EdK Offline
Whipping Boy
*******
Posts: 8,744
Threads: 314
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
oldgoaly (08-03-2013)
#11
08-03-2013, 10:42 AM
I tried a 3/16" mandrel and I got a .230" ID so it's closer. It looks like a mandrel between .1875 and .210 would result in a spring that's close enough.

What I noticed while winding these springs is that the tool could use some form of drag control. Otherwise the ending coils end up a bit larger in diameter than the starting coils. I can see a Mark II tool in the future. Chin

Ed
Reply
Thanks given by:


Messages In This Thread
Making A Spring - by EdK - 07-27-2013, 05:23 PM
RE: Making A Spring - by oldgoaly - 07-27-2013, 06:02 PM
RE: Making A Spring - by EdK - 08-02-2013, 03:18 PM
RE: Making A Spring - by Highpower - 08-02-2013, 04:14 PM
RE: Making A Spring - by EdK - 08-02-2013, 05:02 PM
RE: Making A Spring - by TomG - 08-02-2013, 04:31 PM
RE: Making A Spring - by oldgoaly - 08-02-2013, 04:57 PM
RE: Making A Spring - by EdK - 08-02-2013, 05:04 PM
RE: Making A Spring - by Mayhem - 08-03-2013, 09:59 AM
RE: Making A Spring - by dallen - 08-03-2013, 10:32 AM
RE: Making A Spring - by EdK - 08-03-2013, 10:42 AM
RE: Making A Spring - by oldgoaly - 08-03-2013, 11:21 AM
RE: Making A Spring - by DaveH - 08-03-2013, 11:53 AM
RE: Making A Spring - by EdK - 08-03-2013, 12:33 PM
RE: Making A Spring - by DaveH - 08-03-2013, 02:51 PM
RE: Making A Spring - by allrite - 02-26-2014, 04:50 PM
RE: Making A Spring - by EdK - 02-26-2014, 04:59 PM
RE: Making A Spring - by TomG - 02-26-2014, 06:51 PM
RE: Making A Spring - by f350ca - 02-26-2014, 08:13 PM
RE: Making A Spring - by allrite - 02-27-2014, 12:33 PM
RE: Making A Spring - by stevec - 02-28-2014, 07:04 AM



Users browsing this thread: 2 Guest(s)