Ram clamp handle
#7
I'm thinking I don't like (actually never did like it) the handle that clamps the ram, so I finally set down and drew up a new one, this one I actually did draw on the cad program I bought back in the spring. which I think will look a lot better if I can get a friend that has a CNC Router to cut it for me.

Anyway what ya think?? I know it needs radius's in a couple places but i figure a ball nose end mill will take care of that

[Image: clamp-handle-new.jpg]
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Ram clamp handle - by dallen - 07-29-2013, 01:45 PM
RE: ram clamp handle - by dallen - 07-30-2013, 11:02 AM
RE: ram clamp handle - by EdK - 07-30-2013, 11:44 AM
RE: ram clamp handle - by dallen - 07-30-2013, 12:32 PM
RE: Ram clamp handle - by DaveH - 08-08-2013, 01:21 PM
RE: Ram clamp handle - by dallen - 08-08-2013, 02:29 PM
RE: Ram clamp handle - by dallen - 11-25-2013, 01:57 PM
RE: Ram clamp handle - by awemawson - 11-25-2013, 02:04 PM
RE: Ram clamp handle - by EdK - 11-25-2013, 05:11 PM
RE: Ram clamp handle - by dallen - 11-26-2013, 09:09 AM
RE: Ram clamp handle - by dallen - 11-26-2013, 09:11 AM
RE: Ram clamp handle - by dallen - 08-23-2014, 08:53 AM
RE: Ram clamp handle - by stevec - 08-23-2014, 10:00 AM
RE: Ram clamp handle - by dallen - 08-23-2014, 11:24 AM



Users browsing this thread: 2 Guest(s)