New part for the Cinci lead screw support

[dallen]

thoughts like that would be nice Mayhem if it would get rid of the porosity in the metal, but with all the humidity we have at the moment thats kinda hard. But I think I'm gonna stop playing with this part for now and work on a crank handle as they were cast also.

but for now here's a couple more shots of the casting in the mill.
this one I'm fly cutting off the pad that bolts to the table slide.

this one I was facing off the side that the ( don't know what its called but its used to put the table feed into neutral), I finished this in the lathe as I had to remove it from the mill to check length on the shaper.

and finally on the shaper, its like my old daddy use to say just a little bit off but not sure where. actually I think its in the mounting pad plus one of the bolts I think had been stripped and gunk stuck in it cause I felt something let go on one of them.