08-04-2013, 05:25 PM
worked on this part today started the pattern last night, I have the part but the hex where your suppose to put a wrench has been all chewed up from someone using a pipe wrench on it.
the pattern
![[Image: locking-nut00001.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/locking-nut00001.jpg)
the part front and back
![[Image: locking-nut00002.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/locking-nut00002.jpg)
![[Image: locking-nut00003.jpg]](http://i1222.photobucket.com/albums/dd484/Superdave257/locking-nut00003.jpg)
I pulled it a little too quick and ended up with a shrink spot in it, but it will machine out seeing as how it gets a 1.125 hole in it thats threaded. some sand tearing around the hex but that will clean up, besides the hex needs to be milled so a wrench will sit on the flats square, and not have the draft trying to flip the wrench off.
DA
the pattern
![[Image: locking-nut00001.jpg]](http://s1222.photobucket.com/user/Superdave257/media/locking-nut00001.jpg.html)
the part front and back
![[Image: locking-nut00002.jpg]](http://s1222.photobucket.com/user/Superdave257/media/locking-nut00002.jpg.html)
![[Image: locking-nut00003.jpg]](http://s1222.photobucket.com/user/Superdave257/media/locking-nut00003.jpg.html)
I pulled it a little too quick and ended up with a shrink spot in it, but it will machine out seeing as how it gets a 1.125 hole in it thats threaded. some sand tearing around the hex but that will clean up, besides the hex needs to be milled so a wrench will sit on the flats square, and not have the draft trying to flip the wrench off.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!