08-09-2013, 04:22 PM
measuring scoops? hmmm never thought of that, should work good!
here is a old pic of some small tools, the trick to having a good sprue or riser cutter is "NOT" to bang them on the side to get the sand out! a pat on the end and it pops out.
here is a old pic of some small tools, the trick to having a good sprue or riser cutter is "NOT" to bang them on the side to get the sand out! a pat on the end and it pops out.
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.