Getting carried away
#6
Thanks Ed,
Yep a shiny metal camera, LOL
It was a lot of work but will be rewarding every time I use the lathe.
Every surface was trued up, here is a picture of under the cross slide after at least 20 heavy passes with the grinder allowing it to cool every few, I should have really milled it first but didn't know or think it was that bad until I mounted it to grind. Just goes to show how much it was out.

   

Dave
Reply
Thanks given by:


Messages In This Thread
Getting carried away - by Dave J - 08-15-2013, 09:17 PM
RE: Getting carried away - by TomG - 08-15-2013, 10:57 PM
RE: Getting carried away - by Dave J - 08-16-2013, 12:57 AM
RE: Getting carried away - by Dave J - 08-16-2013, 01:09 AM
RE: Getting carried away - by EdK - 08-16-2013, 06:22 AM
RE: Getting carried away - by Dave J - 08-16-2013, 06:36 AM
RE: Getting carried away - by DaveH - 08-16-2013, 07:07 AM
RE: Getting carried away - by Dave J - 08-16-2013, 07:15 AM
RE: Getting carried away - by DaveH - 08-16-2013, 09:03 AM
RE: Getting carried away - by Micktoon - 08-16-2013, 03:16 PM
RE: Getting carried away - by doubleboost - 08-16-2013, 03:45 PM
RE: Getting carried away - by EdK - 04-18-2014, 12:52 PM
RE: Getting carried away - by Dave J - 04-18-2014, 04:30 PM



Users browsing this thread: 1 Guest(s)