Getting carried away

Thread Modes

Getting carried away

Dave J Offline

Sophmore

Posts: 183
Threads: 22
Joined: Feb 2012
Location: Australia

#13

04-18-2014, 04:30 PM

(04-18-2014, 12:52 PM)EdK Wrote: Reviving an old thread.

Dave,

So I assume you used the horizontal spindle on your mill to do the grinding. Is that correct?

Thanks,
Ed

Thats how I did it Ed with a large surface grinding wheel to get the surface speed up.
I had a tube and container hooked up flooding the arbour support plain bearing to keep any grit out and a old vacuum cleaner hooked up to carry the dust away.
I have way covers on the mill so they just needed a good clean afterwoods.

Dave

Like Post

Thanks given by: EdK

« Next Oldest | Next Newest »

Messages In This Thread

Getting carried away - by Dave J - 08-15-2013, 09:17 PM

RE: Getting carried away - by TomG - 08-15-2013, 10:57 PM

RE: Getting carried away - by Dave J - 08-16-2013, 12:57 AM

RE: Getting carried away - by Dave J - 08-16-2013, 01:09 AM

RE: Getting carried away - by EdK - 08-16-2013, 06:22 AM

RE: Getting carried away - by Dave J - 08-16-2013, 06:36 AM

RE: Getting carried away - by DaveH - 08-16-2013, 07:07 AM

RE: Getting carried away - by Dave J - 08-16-2013, 07:15 AM