The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error




SBL ER40 collet chuck
#1
I made this 5-6 years ago so bear with me if you have seen it before. I am making another body to fit my 1941 SBL heavy 10 and my 1919 SBL 15" which has the same spindle thread. It was pretty easy to make it just took some figuring out. Lets see i have ablock of steel in my left hand and a collet in my right and i need them to fit togther. Simple enough...Bob


Attached Files
.jpg   7 boring nose hole for threading.jpg (Size: 13.16 KB / Downloads: 98)
.jpg   2 chuck body threaded for spindle.jpg (Size: 27.17 KB / Downloads: 95)
.jpg   4 trying collet.jpg (Size: 17.28 KB / Downloads: 95)
.jpg   9 nose threaded.jpg (Size: 17.27 KB / Downloads: 94)
.jpg   12 after shaping to suit.jpg (Size: 27.58 KB / Downloads: 95)
.jpg   1 chuck body.jpg (Size: 17.28 KB / Downloads: 95)
.jpg   3 inside taper cut.jpg (Size: 15.78 KB / Downloads: 95)
.jpg   6 threaded body and taper.jpg (Size: 19.54 KB / Downloads: 95)
.jpg   10 collet body screwed inside nose.jpg (Size: 19.42 KB / Downloads: 96)
.jpg   11 done but needs shaping.jpg (Size: 17.67 KB / Downloads: 96)
.jpg   5 threading body for nose cap.jpg (Size: 18.83 KB / Downloads: 95)
.jpg   8 nose taper cut and hole bored.jpg (Size: 14.94 KB / Downloads: 96)
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
SBL ER40 collet chuck - by aametalmaster - 03-21-2012, 08:51 PM
RE: SBL ER40 collet chuck - by DaveH - 03-22-2012, 10:54 AM
RE: SBL ER40 collet chuck - by EdK - 03-22-2012, 12:03 PM
RE: SBL ER40 collet chuck - by aametalmaster - 03-22-2012, 07:20 PM
RE: SBL ER40 collet chuck - by doubleboost - 03-22-2012, 03:14 PM



Users browsing this thread: 1 Guest(s)