having trouble cutting a taper
#5
Mike.

I have a 3MT to 2MT sleeve up my headstock spindle, the 2MT slips into that.

Rick.

Your notes on accuracy are well taken. I thought I had covered everything but when I went back into the shop I noticed my brand new 2MT to 2JT spigot has a TIR reading of .002 run out in the 3MT to 2MT adaptor.
At the moment I have just Locktited my boss to the spigot and I will now never be able to remove it, that’s fine as they are cheep but the moral of the story is check everything. For what I am making I can live with this slight runout.

It’s been awhile since I have given the lathe a alignment check I will do this some time this week.
While we are on this subject has anyone got some good ideas on making a height gage for the tooling setting on the lathe?

Anthony.
ieezitin, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:


Messages In This Thread
having trouble cutting a taper - by ieezitin - 09-01-2013, 10:36 AM
RE: having trouble cutting a taper - by tekfab - 09-01-2013, 11:13 AM
RE: having trouble cutting a taper - by ieezitin - 09-01-2013, 01:06 PM
RE: having trouble cutting a taper - by f350ca - 09-01-2013, 01:07 PM
RE: having trouble cutting a taper - by ieezitin - 09-01-2013, 01:15 PM
RE: having trouble cutting a taper - by ieezitin - 09-01-2013, 01:23 PM
RE: having trouble cutting a taper - by f350ca - 09-01-2013, 07:02 PM



Users browsing this thread: 1 Guest(s)