MetalworkingFun Forum › Machinery › Lathes v
having trouble cutting a taper

Thread Modes
having trouble cutting a taper
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#11
09-01-2013, 07:28 PM
That's how i do it too just some bluing and if it doesn't wobble and the bluing is wore off normal its good to go...Bob


Attached Files
.jpg   tapers.jpg (Size: 31.51 KB / Downloads: 28)
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
having trouble cutting a taper - by ieezitin - 09-01-2013, 10:36 AM
RE: having trouble cutting a taper - by tekfab - 09-01-2013, 11:13 AM
RE: having trouble cutting a taper - by ieezitin - 09-01-2013, 01:06 PM
RE: having trouble cutting a taper - by f350ca - 09-01-2013, 01:07 PM
RE: having trouble cutting a taper - by ieezitin - 09-01-2013, 01:15 PM
RE: having trouble cutting a taper - by ieezitin - 09-01-2013, 01:23 PM
RE: having trouble cutting a taper - by f350ca - 09-01-2013, 07:02 PM
RE: having trouble cutting a taper - by aametalmaster - 09-01-2013, 07:28 PM



Users browsing this thread: 1 Guest(s)