MetalworkingFun Forum › Machining › General Metalworking Discussion v
Safety First!

Thread Modes
Safety First!
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,795
Threads: 183
Joined: Jun 2012
Location: Farmington Hills, Michigan
#14
09-11-2013, 10:07 AM
(09-11-2013, 10:00 AM)arvidj Wrote:
(09-09-2013, 06:54 PM)TomG Wrote: Since making that video a while back on drilling plastics ...

Tom,

I seem to have missed the "drilling plastic" video. I don't see it on your YouTube site. A link would be appreciated.

Thanks,
Arvid

Arvid,

Try this one:

How to Make a Twist Drill Safe for Use on Brass and Plastics

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: arvidj


Messages In This Thread
Safety First! - by TomG - 09-09-2013, 06:54 PM
RE: Safety First! - by Mayhem - 09-10-2013, 08:20 AM
RE: Safety First! - by TomG - 09-10-2013, 09:33 AM
RE: Safety First! - by EdK - 09-10-2013, 11:54 AM
RE: Safety First! - by DaveH - 09-10-2013, 02:09 PM
RE: Safety First! - by Highpower - 09-10-2013, 03:52 PM
RE: Safety First! - by doubleboost - 09-10-2013, 04:07 PM
RE: Safety First! - by TomG - 09-10-2013, 04:26 PM
RE: Safety First! - by doubleboost - 09-10-2013, 04:33 PM
RE: Safety First! - by TomG - 09-10-2013, 04:44 PM
RE: Safety First! - by Mayhem - 09-10-2013, 05:45 PM
RE: Safety First! - by TomG - 09-10-2013, 06:05 PM
RE: Safety First! - by arvidj - 09-11-2013, 10:00 AM
RE: Safety First! - by TomG - 09-11-2013, 10:07 AM



Users browsing this thread: 1 Guest(s)