Gas Not Getting To Nozzle

[EdK]

(09-21-2013, 03:20 PM)aametalmaster Wrote: Trim your wire stick out where you like it each time before you strike the next arc. Depending what part i am welding at work i usually break my wire flush with the tip then tap the trigger so its there. But i am using gas flux core and it really doesn't like to start on the ball in the wire end...Bob

Bob,

I do cut the wire before every weld. I've been doing that all along. I think I read it somewhere when I first started welding so I've always done it.

Ed